IP-VFC Supported Output Formats
The IP-VFC supports a range of specific, fixed output formats and frequencies. These apply to both SDI and ST 2110 output.
All modes support RGB (Full), YCbCr 4:4:4 and YCbCr 4:2:2 at 10-bit.
All modes at 4K DCI and UHD support BT.2020 colour spaces, whilst all modes at Full-HD support BT.709. Please refer to the Colour Conversion Profile section here.
Supported formats are listed in the table below:
| FPS | 4K DCI (4096 x 2160) | UHD (3840 x 2160) | 2K DCI (2048 x 1080) | Full HD (1920 x 1080) |
|---|---|---|---|---|
| 23.98p | ✔️ | ✔️ | ✔️ | ✔️ |
| 24p | ✔️ | ✔️ | ✔️ | ✔️ |
| 25p | ✔️ | ✔️ | ✔️ | ✔️ |
| 29.97p | ✔️ | ✔️ | ✔️ | ✔️ |
| 30p | ✔️ | ✔️ | ✔️ | ✔️ |
| 50p | ✔️ | ✔️ | ✔️ | ✔️ |
| 59.94p | ✔️ | ✔️ | ✔️ | ✔️ |
| 60p (Mirror) | ✔️ | ✔️ | ✔️ | ✔️ |
GX 3+ support
Section titled “GX 3+ support”The formats the GX 3+ supports are below. For the configurations it supports, covering VFC modes, split modes and sync, see the GX 3+ IP-VFC Support Guidelines.
Specific formats supported in SDI and ST 2110 modes on the IP-VFC when used with the GX 3+ can be seen in the table below.
All video formats are supported when using IP-VFC firmware 26.2 and Designer r34.1 or above.
On earlier firmware the GX 3+ is more limited. FW 25.1 is not validated for the GX 3+ at all, and FW 24.4 supports SDI in Single mode only.
| Frames per second (FPS) | 4K DCI (4096 x 2160) | UHD (3840 x 2160) | 2K DCI (2048 x 1080) | Full HD (1920 x 1080) |
|---|---|---|---|---|
| 23.98p | ✔️ | ✔️ | ✔️ | ✔️ |
| 24p | ✔️ | ✔️ | ✔️ | ✔️ |
| 25p | ✔️ | ✔️ | ✔️ | ✔️ |
| 29.97p | ✔️ | ✔️ | ✔️ | ✔️ |
| 30p | ✔️ | ✔️ | ✔️ | ✔️ |
| 50p | ✔️ | ✔️ | ✔️ | ✔️ |
| 59.94p | ✔️ | ✔️ | ✔️ | ✔️ |
| 60p | ✔️ | ✔️ | ✔️ | ✔️ |